I am about to pick up a TTS mastertune for my bike and I was wondering if someone could suggest a map for me to start off with? I have a 2010 WG with a SE intake and thunderheaders. I will be tuning the bike myself this spring to get it close and then probably go on a little road trip this summer to take it to a place that deals with the TTS systems to have it dyno tuned.

 

The thing comes with a large list of various years and engine combinations. With what you have just look thru these and find as close to your year and setup and use that.
The last page has engine specific stuff and RPM limit and gearing selections.
Hightly suggest you read the whole directions a couple of times and get familiar.

 

no need to go on that long of a road trip..JD,s cycleworks in pa will come pick her up for you and is one of the best tuners around.
heres his number 1-610-297-0321 you will not be disappointed.

 

Looks like CTB009-01 is for the 1580 DBW bikes with air cleaner and Thunderheads.

As suggested above, read the tuning manual then do the VTunes. After the first couple times (learning the vtuning details), you should be able to get a pretty good tune in an afternoon.

Good luck!

 

Thanks guys. I will probably end up and JDs at some point this summer to see what he can do on the dyno for me. But I would like to get it some what dialed in for the spring time.

 

Dave never offered to come and pick my bike up to tune it! I'm going to have to call and speak with him about that.......think maybe he didn't offer because I'm in Oklahoma?

 

ya think i wish you were closer