What do you think about this build?
#1
What do you think about this build?
I have a standard Harley 103 kit with stock heads and a Wood 6-6 cam and Rinehart true duals.
It sure runs better than stock, but I would like to improve how it runs. I'd like to hear what ya'll think about this set up.
Hillside stage three heads. set up with a 85cc chamber and ready to accept a cam in the future that might have a 652 lift. Compression between 10 and 10.5 to 1. Valve size about 1.94 intake and 1.63 exhaust.
Rod's Performance would true and balance the crank & flywheel and install timkin bearings.
I would like to keep the flat top pistons in place to avoid the cost of pistons and cylinder work.
What are your opinions on this combination?
Would I have to have new pistons for enough valve relief and compression?
It sure runs better than stock, but I would like to improve how it runs. I'd like to hear what ya'll think about this set up.
Hillside stage three heads. set up with a 85cc chamber and ready to accept a cam in the future that might have a 652 lift. Compression between 10 and 10.5 to 1. Valve size about 1.94 intake and 1.63 exhaust.
Rod's Performance would true and balance the crank & flywheel and install timkin bearings.
I would like to keep the flat top pistons in place to avoid the cost of pistons and cylinder work.
What are your opinions on this combination?
Would I have to have new pistons for enough valve relief and compression?
#3
#6
2nd that!!!!!!! A REAL NICE MASSAGE on those heads. And that WOODS 6 cam is tough to beat for versatility.
Last edited by hpfatboy; 01-12-2009 at 12:16 AM.
#7
Trending Topics
#8
disclaimer
i dont have hillside heads " yet "
but im one of those nuts who reads and studies more that you can possibly imagine , then i start sending pms/emails before moving on to phone calls .all that incrediblly wastefull has taught me that scott and the guys at hillside have a GREAT rep for not only quality work but going the extra mile in customer service.
i dont have hillside heads " yet "
but im one of those nuts who reads and studies more that you can possibly imagine , then i start sending pms/emails before moving on to phone calls .all that incrediblly wastefull has taught me that scott and the guys at hillside have a GREAT rep for not only quality work but going the extra mile in customer service.
Thread
Thread Starter
Forum
Replies
Last Post
blksoftail
Exhaust System Topics
7
07-15-2011 11:30 AM
Karsten
Exhaust System Topics
22
06-12-2010 02:02 PM