Where can I get the most bang for my $ when lookin for more low end torque. I have done the SE air, V&H headers and Ovals, PCIII and dyno tuned. She runs like a bat out of hell but hard to get off the line. Looking for suggestions. Thanks
Goatman

 

That's a very open ended question. The sky is the limit....

If you want something simple & easy... a set of Head-Quarters HQ-500TC cams, with the possible addition of a big bore kit to bump'er up to a 103 would make a huge difference and leave room for more upgrades later w/o having to sacrifice the investment you've already made.

If ya'd like more, check out this site & size up your own build: http://www.head-quarters-usa.com/products.htmlthen click the RED "Click Here to begin".link from that site.

 

If you're happy with the way the motor runs overall, I'd consider a gearing change. Each gear is a bit higher than previous years. Right now the good options aren't toocheap unless you can do the labor.

 

Wouldn't even think about doing any engine work, when I take things apart, I usually have to buy a new one.