90 FLTC Engine Removal
#41
Ok, any tricks or tips on removing the oil tank? I'm annoyed and taking a break...
The top back corner of the oil tank is tucked under a chrome piece that extends rearward with the right shock bolted to/through it. It doesn't look like the tank can slip out from under it because of how deep the front edge of the tank sticks into the frame. So do I have to unbolt the right shock and whatever else is attached to that piece to get it out of the way of the oil tank?
The top back corner of the oil tank is tucked under a chrome piece that extends rearward with the right shock bolted to/through it. It doesn't look like the tank can slip out from under it because of how deep the front edge of the tank sticks into the frame. So do I have to unbolt the right shock and whatever else is attached to that piece to get it out of the way of the oil tank?
Last edited by D1gger; 05-02-2012 at 08:01 PM.
#42
Take those three 1/2" bolts out at the corners, take the phillips screw out of the chrome cover above the rear strut and pull the cover off. You shouldn't have to remove the shock. Tank should slide out, unhook hoses and clean it out. Replace hoses, they are cheap. Breath. It's really that easy.
#43
Take those three 1/2" bolts out at the corners, take the phillips screw out of the chrome cover above the rear strut and pull the cover off. You shouldn't have to remove the shock. Tank should slide out, unhook hoses and clean it out. Replace hoses, they are cheap. Breath. It's really that easy.
#45
Got it. The top rear 1/2" bolt held both the trim and the corner of the tank and there was only 1 phillips head screw securing the rest of it. I seriously thought the shock upper bolt was through that piece, not under a cut-out. Tank is out, flushed several times until the inside is nice and shiny looking. Now it's sitting in front of a fan to air out the remaining kerosene before I slosh some fresh clean oil through it to coat the inside surfaces well.
My trombone snake idea worked PERFECTLY! I was able to get all the lines perfectly clean with it. Since they are so clean and the ends still look solid without any splits or cracks, I see no reason to replace them.
As soon as I find the package of small hose clamps I bought a little while back, I will head back to the garage to oil seal the inside of the tank and put the oil system back together. I feel productive today! LOL!
My trombone snake idea worked PERFECTLY! I was able to get all the lines perfectly clean with it. Since they are so clean and the ends still look solid without any splits or cracks, I see no reason to replace them.
As soon as I find the package of small hose clamps I bought a little while back, I will head back to the garage to oil seal the inside of the tank and put the oil system back together. I feel productive today! LOL!
#47
#48
#49
I can send you one when I get home but I don't think you'll need it. where you screw on the filter there is a nut built into the adapter, hold the housing from above and tighten that, don't overtighten it.
#50
Just got back from the dealer. Picked up a new oil filter, rotor screws, locking washers for the inner primary housing, new crankcase o ring and a new seal for the clutch shaft in the back of the primary housing. Next trip will be the main primary housing gasket, primary oil, new plugs, wires and oil. The engine went out Monday so it should be at Harley by now. Its all starting to come together...