need some help with evo
#1
need some help with evo
I have this 95 elec glide standard with a cv carb.
the problem is when I start this thing and it warms up I push in the enrichener the bike stumbles and dies.
If you tweak the throttle you can keep it running, it will run for about twenty seconds and then its like it runs out of fuel and cuts out.
the bike is pretty much a stock police standard e-glide it has some leaks here and there.
the cv carb is jetted for the drag pipes i have.
I dont know if its in the idle cuircit or vacume leak.
any help would be appreaciated.
the problem is when I start this thing and it warms up I push in the enrichener the bike stumbles and dies.
If you tweak the throttle you can keep it running, it will run for about twenty seconds and then its like it runs out of fuel and cuts out.
the bike is pretty much a stock police standard e-glide it has some leaks here and there.
the cv carb is jetted for the drag pipes i have.
I dont know if its in the idle cuircit or vacume leak.
any help would be appreaciated.
#4
#6
thanks I'll pull it and clean it...lol
It started last sept and has been sitting since fired it up today and this stuff started.
It warms up fine with the enrichiner, but when i push it in it runs for about 20sec then falls off and lumps real bad.
tweak the trottle and it runs again for a little while then back to lumping.
I'll go through the carb, it needs it.
thanks.
It started last sept and has been sitting since fired it up today and this stuff started.
It warms up fine with the enrichiner, but when i push it in it runs for about 20sec then falls off and lumps real bad.
tweak the trottle and it runs again for a little while then back to lumping.
I'll go through the carb, it needs it.
thanks.
#7
Trending Topics
#9
#10
found it
I went ahead and rebuilt the carb and glued in the intake with hylomar.
fired the bike up ready to go and the same crap, warms up and stumbles.
started to go through the manifold, the carb gasket looked real good.
I decided to put on a vac pump and check the VOES.
the voes wont hold a vaccum, i can get it to reach 5inches of mercury but it wont stay.
also found the vaccum line to the petcock had a hole.
so my question is this shouldnt the voes hold vaccum, not leak it off.
It will build up to 5-6 inches but then dropes off??????
thanks everyone for the help!
I do appreciate it...
fired the bike up ready to go and the same crap, warms up and stumbles.
started to go through the manifold, the carb gasket looked real good.
I decided to put on a vac pump and check the VOES.
the voes wont hold a vaccum, i can get it to reach 5inches of mercury but it wont stay.
also found the vaccum line to the petcock had a hole.
so my question is this shouldnt the voes hold vaccum, not leak it off.
It will build up to 5-6 inches but then dropes off??????
thanks everyone for the help!
I do appreciate it...
Last edited by houseoutnumbered; 02-22-2011 at 06:22 PM. Reason: just wanted to thank everyone