Counter Sunk Rotor Washers
#1
#3
#4
I think I found it...My Eyesight is Off... 3/8 counter sunk...Not all Rotors are Flat..I have more than a couple here with counter sunk rotor Fasteners.. I will peruse the Parts Fiche..maybe find those Locking washers...
@t150vej I never thought there was much difference in Shovelhead vs Evo rotors.....certainly Not Early ones..But..I do Not pay that close attention...Mix and Match at my place..
Last edited by Racepres; 09-07-2024 at 10:08 AM.
#5
#6
Yes...Correct...I just noticed, depending on the Caliper..some FXR's and I bet others, used those CounterSunk fasteners.. Heads flush with Rotor Surface..
Now..What was the Deal with the Darn Toothed Washer???
Now..What was the Deal with the Darn Toothed Washer???
#7
The only time I ever seen counter song screws for the front rotors were with aftermarket rotors and I even had one on my Fatboy.. The rim was aftermarket that had a wider hub.. It was a large spoke 18" rim where I had to use a rotor that had a quarter inch offset on it and that had the countersunk screws..
Trending Topics
#8
The only time I ever seen counter song screws for the front rotors were with aftermarket rotors and I even had one on my Fatboy.. The rim was aftermarket that had a wider hub.. It was a large spoke 18" rim where I had to use a rotor that had a quarter inch offset on it and that had the countersunk screws..
But... What 3/8 Countersunk Rotor Bolts used Lock Washers????
#9
#10