1997 fatboy bobber build
#1
1997 fatboy bobber build
figured I'd come over here to start a build thread.
1997 fatboy. all tins either scratched or dented from a low side. picked the bike up from a guy who cant ride anymore
going to make a sorta rigid looking bobber outta it. here is how it looked when i got it, and here is how it looks as I await parts from black friday
if you squint it almost looks mint..lol 27k miles new carb new fluids new seat rashed pipes rashed master cylinder rashed brake lever rear fender scratched headlight rashed
dented left side tank
dented right side tank
rashed air cleaner cover
dented horn cover
loose shifter linkage
1997 fatboy. all tins either scratched or dented from a low side. picked the bike up from a guy who cant ride anymore
going to make a sorta rigid looking bobber outta it. here is how it looked when i got it, and here is how it looks as I await parts from black friday
if you squint it almost looks mint..lol 27k miles new carb new fluids new seat rashed pipes rashed master cylinder rashed brake lever rear fender scratched headlight rashed
dented left side tank
dented right side tank
rashed air cleaner cover
dented horn cover
loose shifter linkage
The following users liked this post:
Carlrf (12-30-2020)
#2
current status:
offerup tank so i can ride bike while new tank gets sealed and painted
installed
purple....... not my cup of tea but ridable
cutting rear fender struts off
sooooo ugly...
rsd tracker fender. but was just a mock up for a chopped fender in future. ill be getting the fender attached to swingarm and no fender struts.
offerup tank so i can ride bike while new tank gets sealed and painted
installed
purple....... not my cup of tea but ridable
cutting rear fender struts off
sooooo ugly...
rsd tracker fender. but was just a mock up for a chopped fender in future. ill be getting the fender attached to swingarm and no fender struts.
#3
shinko 270 16x5.00 front and rear tires
older looking clutch lever
3 wire turn signal to make brake light from
drag scorpion seat
new tubes
weld on swingarm fender mounts
gas cap
single throttle cable, 1" throttle sleeve and cheap grips for now
5 3/4 headlight
weld on backbone tank bungs
5" rear fender
2.1 gallon wasle mid tunnel tank
1\" axle mount plate holder
Last edited by gartec81; 12-02-2020 at 10:04 PM.
The following 5 users liked this post by gartec81:
Architect (12-03-2020),
daven9113 (12-04-2020),
drummin1 (01-27-2021),
jyx (12-03-2020),
Low budget Dan (12-03-2020)
#5
Join Date: Apr 2010
Location: Long Island, New York
Posts: 8,082
Received 5,424 Likes
on
2,765 Posts
The following users liked this post:
gartec81 (12-04-2020)
The following users liked this post:
gartec81 (12-04-2020)
#7
The following users liked this post:
gartec81 (12-04-2020)
Trending Topics
#8
The following users liked this post:
gartec81 (12-04-2020)
#9
The following 2 users liked this post by gartec81:
98hotrodfatboy (12-04-2020),
Yankee Dog (12-04-2020)
#10
Join Date: Apr 2010
Location: Long Island, New York
Posts: 8,082
Received 5,424 Likes
on
2,765 Posts
The following users liked this post:
Tee&Vee (12-08-2020)