Primary leak?
#11
Join Date: Jan 2011
Location: Haslet Texas
Posts: 21,008
Likes: 0
Received 4,361 Likes
on
1,953 Posts
Man seriously just change the outer primary seal and if that doesn't work then remove the inner primary and change all the seals.
#13
#14
#15
Join Date: Jan 2011
Location: Haslet Texas
Posts: 21,008
Likes: 0
Received 4,361 Likes
on
1,953 Posts
If you bought the metal/foam primary gasket then you can reuse those over and over so as I said before just replace the primary gasket and see what that does for you.
#16
#17
Primary leak?
Found the leak. Not quite sure what went wrong here. Explains the whine I heard. Thoughts?? Jackshaft leaking as well. Looks like the oil seal for the inner primary mangled itself. I can't make sense of it.
Edit...I think I had to have installed the seal backwards? Everything else looks find. This is the one seal I didn't buy. It's a double lip what side would the washer metal side go? Facing primary or facing inside to trans?
Edit...I think I had to have installed the seal backwards? Everything else looks find. This is the one seal I didn't buy. It's a double lip what side would the washer metal side go? Facing primary or facing inside to trans?
Last edited by br549A1; 09-11-2015 at 08:27 PM.
#18
Join Date: Jan 2011
Location: Haslet Texas
Posts: 21,008
Likes: 0
Received 4,361 Likes
on
1,953 Posts
Found the leak. Not quite sure what went wrong here. Explains the whine I heard. Thoughts?? Jackshaft leaking as well. Looks like the oil seal for the inner primary mangled itself. I can't make sense of it.
Edit...I think I had to have installed the seal backwards? Everything else looks find. This is the one seal I didn't buy. It's a double lip what side would the washer metal side go? Facing primary or facing inside to trans?
Edit...I think I had to have installed the seal backwards? Everything else looks find. This is the one seal I didn't buy. It's a double lip what side would the washer metal side go? Facing primary or facing inside to trans?
Look inside the inner lip and you should see a small spring.
#19
Primary leak?
Has 2 one on each side it's a double lip. I can't find the instructions online. It's all ***** 25-3102
It was definitely rubbing. I can't remember which way it was on now but one way it slides in easy so I think it was washer side towards the trans vs washer side towards the primary. Not sure what to do now. figures it's the only seal I didn't order. It is still snug on the main shaft I think it could be reused if I can figure out what way it should be installed for sure
It was definitely rubbing. I can't remember which way it was on now but one way it slides in easy so I think it was washer side towards the trans vs washer side towards the primary. Not sure what to do now. figures it's the only seal I didn't order. It is still snug on the main shaft I think it could be reused if I can figure out what way it should be installed for sure
#20
Join Date: Jan 2011
Location: Haslet Texas
Posts: 21,008
Likes: 0
Received 4,361 Likes
on
1,953 Posts