This bike caught my eye and thought was good but simple build. Hated to tear up my rear fender because the paint is so good.

 

100% reproduction for sure.

 

subscribed. cool project. any idea what you are doing with the parts you swap out ? i might be interested in some of them.

 

What parts are you looking for? I would sell what I'm swapping.

split tanks
lepera seat
Fatboy compete front end
handle bars
Tracker rear fender with struts

 

sent you a p.m.

 

3 wire front signal from a 2000 sporster

Red lens put on it with trim ring so its running red at all times

Going to cut the fender length shorter so the end of rear fender sits directly above the axle location.

Will cut the fender shorter and go with small battery and relocate wires so seat sits flat on frame. Seat will also mount to the fender so it will be set farther back on frame than the stock seat location. This will also make the bike look longer

 

You putting pegs on it? I might want the floorboard assemblies Gartec. And welcome back

 

when you find the manufacturer of choice see about weight ratings. Those older bikes weigh much less than the newer bikes. With a 2" shorter travel i think it may bottom out more readily. Not calling you fat! Hahaha

 

If they make a reproduction springer for an XA, it will be longer for military uses. Good luck.

 

Made a big mistake on the tires. I love the look of the vintage tread. But it rides like ****. Literally feels like bike wants to lowside under any turning. Tracks every line in tge road and makes me second guess every input in the bars. Will be unfortunately changing out to something more modern....

5" rear ribbed fender put on tire for ideads of fender placement

Wassle 2.1 gallon tank. Its just a mock up but i fo like the lines of it.

Might swap the bars but the lines of the bike are sorta there. If you squint hard enough it looks good

Going to run a panhead/shovelhead handlebar clamp