Frustration builds on my 107 build!
#1
Frustration builds on my 107 build!
I have been at a dead stop for two weeks now. It is all over getting the correct head gaskets. I have the cylinders on and can't go any further Until I get some .040' thick head gaskets and that has been like pulling teeth.
I had my bottom end built by Dark Horse. I got the Full Monte, weld, plug, balance, true the timken upgrade a H beam rods. It is a thing of beauty seeing those rods setting in the case.
So here is where the trouble starts. I'm checking my deck height and I get +.006". A wee bit much for comfort. I give the supplier of the kit a call and discuss this with him. We decide that a .040 gasket is the thing to do.
OK, lets get those gaskets and get on with this thing. Well here I sit two weeks later and still do not have the correct gaskets. I have received two different shipments of the same incorrect gasket but, I still do not have what I need, a 3.940 x .040 cometic gasket.
My intention here is not to bash The supplier of the kit. I spoke with the owner today and we are working to get this resolved. Hopefully in the next day or two. they have to get the gaskets from a supplier, who apparently thinks a 103 and a 107 take the same gasket.
on a positive note, I added the Diamond engineering twelve point bolt kit. That really adds a clean look to the whole engine area.
And I have a New D&D Fat Cat sitting there ready to install.
I had my bottom end built by Dark Horse. I got the Full Monte, weld, plug, balance, true the timken upgrade a H beam rods. It is a thing of beauty seeing those rods setting in the case.
So here is where the trouble starts. I'm checking my deck height and I get +.006". A wee bit much for comfort. I give the supplier of the kit a call and discuss this with him. We decide that a .040 gasket is the thing to do.
OK, lets get those gaskets and get on with this thing. Well here I sit two weeks later and still do not have the correct gaskets. I have received two different shipments of the same incorrect gasket but, I still do not have what I need, a 3.940 x .040 cometic gasket.
My intention here is not to bash The supplier of the kit. I spoke with the owner today and we are working to get this resolved. Hopefully in the next day or two. they have to get the gaskets from a supplier, who apparently thinks a 103 and a 107 take the same gasket.
on a positive note, I added the Diamond engineering twelve point bolt kit. That really adds a clean look to the whole engine area.
And I have a New D&D Fat Cat sitting there ready to install.
#2
#3
I just left it in the hands of the kit supplier, said he has a connection there.
#5
They say 3.938" on the package but the measure 3.955 and are .027 thick. the .040" thick is what I am having a hard time getting a hold of.
#7
Trending Topics
#8
Thread
Thread Starter
Forum
Replies
Last Post