Replace everything it not ??
#11
I think what you’re seeing is probably a reflection.. some of these pictures are up really close and the light plays tricks on the camera… they actually look worse in these pictures
#12
#13
Yeah, unless you have torque plates, micrometers and bore gauges (not telescoping) you would be better off taking them to a machine shop that specializes in this type of work.
Looks like some of scratches mae be from assembly, like from the ring compressor. And then some from foreign objects on the cylinder sutface, although without a good picture of the cylinders it's hard to say.
Paul
Looks like some of scratches mae be from assembly, like from the ring compressor. And then some from foreign objects on the cylinder sutface, although without a good picture of the cylinders it's hard to say.
Paul
#14
torque plate & check the cylinders with a bore gauge.pistons look like they were inatalled dirty or your getting debris from somewhere else (could be the start of rod bearings going south) dosnt look like S&S stuff though,they use a 2mm oil ring and the oil rings look bigger than that.
Thread
Thread Starter
Forum
Replies
Last Post