My engine build
#21
My question was not one of if, BUT what. Definitely getting the crank done. Did a little research and made some calls, think I am just getting a true, plug, and weld done.
Haven't gotten around to cleaning and inspecting the oil pump yet, 12 hours at work (gunna need that OT money!)....hoping to get it done tomorrow, will post pics
Haven't gotten around to cleaning and inspecting the oil pump yet, 12 hours at work (gunna need that OT money!)....hoping to get it done tomorrow, will post pics
#22
#23
The following users liked this post:
LQQK_OUT (02-12-2020)
#24
The following 2 users liked this post by nutsandbolts5212:
98hotrodfatboy (02-12-2020),
Sc0- (03-28-2020)
#25
#26
#28
#29
There is a reason why there is a long turn around at Hoban Brothers; they are the best.
#30
Aight, got the oil pump wiped down real quick and inspected. The feed gears look aight, some wear as suspected, can start to feel it with fingernail.
Now the scavenge gerotors...the inner side look aight, but the outer side that ride in the oil pump scored heaviest. On the gerotor it is more less uniform around, definitely catches the finger nail. But it is only in a certain area of the pump body.
Now the scavenge gerotors...the inner side look aight, but the outer side that ride in the oil pump scored heaviest. On the gerotor it is more less uniform around, definitely catches the finger nail. But it is only in a certain area of the pump body.