Shovelhead pistons orientation
#1
Shovelhead pistons orientation
Hey guys,
I bought a set of shovelhead pistons from VTwin
http://www.vtwinmfg.com/webapp/wcs/s...102_3290921_-1
I cannot seem to figure out orientation, there is no markings showing intake/exhaust. S&S has intake stamped on top of their piston.
Could it be there is no difference?
Thanks for your help!
I bought a set of shovelhead pistons from VTwin
http://www.vtwinmfg.com/webapp/wcs/s...102_3290921_-1
I cannot seem to figure out orientation, there is no markings showing intake/exhaust. S&S has intake stamped on top of their piston.
Could it be there is no difference?
Thanks for your help!
#2
#3
I have measured the width of the indents and they measure the same, they appear to be slightly offset from one another in location to wrist pin, but really hard to see that. I just find it odd that they did not give any directions and even the ones on the link I sent were of no help. I have reached out to VTwin manufacturing to see what they have to say.
#4
#5
Thread
Thread Starter
Forum
Replies
Last Post