Street glide turn signal relay location
#11
I installed led turn signals and developed “hyper flash” so I asked here where the relay was located. One of you wise all knowing gentlemen informed me that Harley doesn’t use a relay and what I needed was a load equalizer.
Now that I’ve installed a load equalizer, you’re still calling me an idiot?
Now that I’ve installed a load equalizer, you’re still calling me an idiot?
You chose to ignore my post.
No one in this thread suggested a "Load Equalizer", and no one called you an idiot.
Last edited by Dan89FLSTC; 04-22-2021 at 10:51 AM.
#13
#14
When I first looked at the picture I was thinking that the badlands module was an AM replacement signal module but on second and third look at the picture, that was just an RBT module that was installed, the part behind it with the grey connector is the TSM so not sure what is going on, what is it doing? Is it turning over but not starting or is it not even turning over? Does the start relay click? As far as the load balancer a goes, did you install just the resistors one on each side, is one side of the resistor to the BR or V and the other to ground? If not this is the way it needs to be installed not inline with the hot or ground.
Last edited by Zanthamos; 04-22-2021 at 10:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post
jfkroadglide08
Want To Buy Motorcycles/Parts/Accessories
0
05-09-2013 12:38 PM
Duggr
Want To Buy Motorcycles/Parts/Accessories
5
06-02-2011 09:32 PM