Power switch contacts/ wire getting hot. 95 HD FLSTC...
#1
Power switch contacts/ wire getting hot. 95 HD FLSTC...
I'm trying to figure out if this wire/ contact is suppose to be getting hot when in the on position. It starts to get hot, but doesn't get to the point where it starts smoking or melting the wires. It just confusing that it's doing this. Can anyone tell me if its wired correctly, I attached a photo of the switch and the pen is point to where it gets hot.
#2
I'm trying to figure out if this wire/ contact is suppose to be getting hot when in the on position. It starts to get hot, but doesn't get to the point where it starts smoking or melting the wires. It just confusing that it's doing this. Can anyone tell me if its wired correctly, I attached a photo of the switch and the pen is point to where it gets hot.
#3
Thanks for the reply. I think k it might be wired up wrong but I have no wire diagram and I got the bike this way. When i switch to accessories, nothing lights up or wont start. So I'm not sure it's wired up correctly and Looks like it had been replaced already, as the switch looks newer then the plate. If anyone on here has a wire diagram or can flash a photo of there wire set up, would be grate.
Thread
Thread Starter
Forum
Replies
Last Post
bobbyw47
Softail Models
11
04-27-2011 12:38 PM