Black Powdercoated Harley Belt Pulley, 1" Belt, Front Tranny Pulley, 11.8" Rotor
#1
Black Powdercoated Harley Belt Pulley, 1" Belt, Front Tranny Pulley, 11.8" Rotor
Harley 66T 1" Belt Pulley Powdercoated Black For 07 & Up Dyna - $130 Shipped
Harley 32T Front Transmission Pulley/Sprocket - $35 Shipped
Harley 131T 1" Wide Drive Belt - $70 Shipped
Or make an offer on everything! Message me if interested! Everything came off a 2011 Street Bob with under 5K on it.
Harley 32T Front Transmission Pulley/Sprocket - $35 Shipped
Harley 131T 1" Wide Drive Belt - $70 Shipped
Or make an offer on everything! Message me if interested! Everything came off a 2011 Street Bob with under 5K on it.
Last edited by Jeezy; 09-26-2014 at 02:55 PM.
#4
I hate to highjack your thread for a minute...but I have a few questions about this sick bike. I'm in the process of throwing some Tbars on the front end of my FXDC and was wondering what the total rise and width of those bars are, and how much you had to extend the cables (total length.. since stock FXDB cables are longer than FXDC cables)? Also, exactly what seat is that in the pic? I appreciate your input... I know you're just tryin to sell **** here. ha
#5
I hate to highjack your thread for a minute...but I have a few questions about this sick bike. I'm in the process of throwing some Tbars on the front end of my FXDC and was wondering what the total rise and width of those bars are, and how much you had to extend the cables (total length.. since stock FXDB cables are longer than FXDC cables)? Also, exactly what seat is that in the pic? I appreciate your input... I know you're just tryin to sell **** here. ha
http://www.westcoast-tbars.com/Produ...ductCode=WC252
http://www.lepera.com/seat_pgs/v3_Dy...php?SEATID=134
http://www.lepera.com/seat_pgs/v3_Dy...php?SEATID=132
#6
The bars are Westcoast MX T-Bars and they are 16" height and 31.5" wide with 3.5" of pullback. I used all stock cables and they fit just fine. I had to cut the zip tie holding the throttle cable to the neck of the frame to get some extra slack, but other than that the stock cables worked fine. The seat is a Lepera Silhouette. If you're looking to get something similar I would go with the "Silhouette Deluxe" instead. I got rid of that one because it wasn't that comfortable.
http://www.westcoast-tbars.com/Produ...ductCode=WC252
http://www.lepera.com/seat_pgs/v3_Dy...php?SEATID=134
http://www.lepera.com/seat_pgs/v3_Dy...php?SEATID=132
http://www.westcoast-tbars.com/Produ...ductCode=WC252
http://www.lepera.com/seat_pgs/v3_Dy...php?SEATID=134
http://www.lepera.com/seat_pgs/v3_Dy...php?SEATID=132
I had a feeling that was a Silhouette... I had the Bare Bones before and returned it b/c it was so uncomfortable. Shame the Silhouette doesn't seem much better.
Well thanks for the info. Good job on the bike!
Thread
Thread Starter
Forum
Replies
Last Post