Lots of Parts - Rims, Trees, Tires, Lowers, etc. Most are Black
#1
Lots of Parts - Rims, Trees, Tires, Lowers, etc. Most are Black
Got a lot of parts here to move, some i may end up using myself or would sell if the price was right.
Prices include shipping to the US!
Black Stock Dyna air cleaner cover w/Stage 1 Filter - $100
This is off my 08. Trim ring was removed for powdering. NOW INCLUDES STAGE 1 FILTER, BACKING PLATE, BOLTS, ETC. FULL BOLT ON!
Black brake lever - $30
Pretty sure this is off a sportster, not a Dyna.
Black electrical cover - $25
Not sure what this is off of, maybe a newer dyna? bought it to use on mine, but mine has 2 bolts through the face to hold it on, this one has a tab at the bottom. Small scratch on the side.
Stock 08 Street Bob Wheels/Rotors/Pulley - $225
Front has a tire on it, but its bad so it will be removed prior to shipping.
Prices include shipping to the US!
Black Stock Dyna air cleaner cover w/Stage 1 Filter - $100
This is off my 08. Trim ring was removed for powdering. NOW INCLUDES STAGE 1 FILTER, BACKING PLATE, BOLTS, ETC. FULL BOLT ON!
Black brake lever - $30
Pretty sure this is off a sportster, not a Dyna.
Black electrical cover - $25
Not sure what this is off of, maybe a newer dyna? bought it to use on mine, but mine has 2 bolts through the face to hold it on, this one has a tab at the bottom. Small scratch on the side.
Stock 08 Street Bob Wheels/Rotors/Pulley - $225
Front has a tire on it, but its bad so it will be removed prior to shipping.
Last edited by MattFXDB; 03-03-2014 at 01:54 PM.
#6
Sissy bar should fit all dynas. It's wider than normal since it's off a wide glide but not my much. Many forum members have these mounted on dynas narrower than a wide glide. Just takes a but of bending which I understand can be done by hand. It mounts between the fender and strut using the existing bolts.
The round cover is 7 3/4 inches inside diameter.
The plate holder is mounted to the bike where the left rear turn signal is. It mounts between the strut and the signal mount. It has a connector on the end of the wire that my bike does not have a mate for. It's just 2 wires though, probably a hot and a ground. Those wires would just need to be spliced in to something else.
The round cover is 7 3/4 inches inside diameter.
The plate holder is mounted to the bike where the left rear turn signal is. It mounts between the strut and the signal mount. It has a connector on the end of the wire that my bike does not have a mate for. It's just 2 wires though, probably a hot and a ground. Those wires would just need to be spliced in to something else.
#7
Sissy bar should fit all dynas. It's wider than normal since it's off a wide glide but not my much. Many forum members have these mounted on dynas narrower than a wide glide. Just takes a but of bending which I understand can be done by hand. It mounts between the fender and strut using the existing bolts.
No body would ever know it wasn't intended to be there.
Trending Topics
#8
#9