Custom Dynamics bullet style LED turn signal bulbs/inserts
#1
Custom Dynamics bullet style LED turn signal bulbs/inserts *** SOLD ***
*** SOLD ***
Plug and Play - No Cutting, No Splicing; 48 Wide Angle Super Bright Next Generation Genesis LEDs per Cluster. Red LEDs for rear. If you use 1157 type bulbs, you can replace them with these bright LEDs. Now you can really be seen at night.
Part number GEN200-R-1157
I ordered the wrong set of LED inserts (I needed 1156), but didn't notice until it was way too late to return them. Great opportunity to save a bundle.
$55 shipped.
Plug and Play - No Cutting, No Splicing; 48 Wide Angle Super Bright Next Generation Genesis LEDs per Cluster. Red LEDs for rear. If you use 1157 type bulbs, you can replace them with these bright LEDs. Now you can really be seen at night.
Part number GEN200-R-1157
I ordered the wrong set of LED inserts (I needed 1156), but didn't notice until it was way too late to return them. Great opportunity to save a bundle.
$55 shipped.
Last edited by NeverEnoughToys; 02-16-2014 at 10:05 AM.
#2
#4
These color on these is RED. I'm not aware of any states or countries that allow red on the front signals (though I could be wrong). Shipping to other countries will be more (whatever extra the USPS charges).
They are designed to put inside the bullet housing (not the flat one) as a direct replacement for the bulb. You take out the bulb, plug in the metal plug base (which looks just like your normal incandescent plug base), and put the lens back on directly over the LED plate. The lens holds the LED plate flat.
The key on this is to look at the bulbs you have now. There are two types. The 1156 has the two side pins directly opposite from each other. The 1157 has the pins offset from each other (as you can see in the left base in the picture). I didn't check mine, which is why I ended up with the wrong one.
Make sure you need the 1157 and that RED is ok.
They are designed to put inside the bullet housing (not the flat one) as a direct replacement for the bulb. You take out the bulb, plug in the metal plug base (which looks just like your normal incandescent plug base), and put the lens back on directly over the LED plate. The lens holds the LED plate flat.
The key on this is to look at the bulbs you have now. There are two types. The 1156 has the two side pins directly opposite from each other. The 1157 has the pins offset from each other (as you can see in the left base in the picture). I didn't check mine, which is why I ended up with the wrong one.
Make sure you need the 1157 and that RED is ok.
#6
Yes, they are the dual-intensity versions. The 1157's are on the same page (http://www.customdynamics.com/harley...rn_signals.htm). The key thing to remember is that the pins are offset.
#7