(Must Read) FXDB parts to fund winter mods!
#1
(Must Read) Dyna parts and accessories to fund winter mods!
Alright so I am changing the direction of the Street Bob again. I have decided to pull the trigger and cut the sruts for a swing arm mounted fender. I am selling so stuff to pay for the mods.
I also have the stock Street Bob tailight, make an offer.
Never mounted Dunlop GT502 180/60B17 $100 plus shipping - SOLD
Bad G customs bag, used left hand side. (stitches in top to strengthen in the wind) $50 plus shipping
FXDWG factory sissy bar $50 plus shipping - SOLD
Custom rear fender (No Dyna contour lines) I had it powdercoated by Joe. It is very close to Factory Red Hot Sunglo.
I have over $400 in it (not looking to get that out of it, but please do not insult me) $200 obo plus shipping - SOLD
Kurakyn Plug-N-Play (with no screws) $100 plus shipping
I also have the stock Street Bob tailight, make an offer.
Never mounted Dunlop GT502 180/60B17 $100 plus shipping - SOLD
Bad G customs bag, used left hand side. (stitches in top to strengthen in the wind) $50 plus shipping
FXDWG factory sissy bar $50 plus shipping - SOLD
Custom rear fender (No Dyna contour lines) I had it powdercoated by Joe. It is very close to Factory Red Hot Sunglo.
I have over $400 in it (not looking to get that out of it, but please do not insult me) $200 obo plus shipping - SOLD
Kurakyn Plug-N-Play (with no screws) $100 plus shipping
Last edited by nichiowa; 10-14-2012 at 11:36 AM.
#3
I am not sure how different the years are but it has two straps that go around the srut and one on the bottom that goes through a loop in the belt guard. It looks like the bikes are the same but I am not sure of specifics. If you want to measure, the bag has the three straps, the top two are 10" center to center and the loop on the bottom is approx 8" below the strut. The top two loop up and down and the bottom loops left to right.
#7