I have a 97' WG & my rear motor mount broke this past w-end & I'm picking up the new one tomorrow from H-D shop..for those that have gone through this procedure already any advice/tips would be greatly appreciated..thank you!!

 

Try and get the bike upright & level, then support the engine ( with say a bottle jack or similar) just a bit to get the bolts out. It may be better if you have someone around to hold one extremety of the bolt while you turn the other. It's pretty straight up bolt on, plug'nplay.

 

Once fitted, slacken all your motor mount bolts (front and rear) run the motor for a few minutes and then tighten them all to spec.