New Dual Disc Part Numbers!
#132
doesn't matter. Crazy as it sounds, the caliper is not really involved other than doing its normal job.
Last edited by cvaria; 10-26-2016 at 03:15 PM.
#134
Cant answer that one. i would say none other than price. But, the mounts are shifted around on the various bikes. Check here and compare the bob sliders to the low rider.... http://partstream.arinet.com/Mobile/...FEGHaZ5Q2.html
Multihdrdr is out there watching and will chime in at some point.
#135
#137
Hmm...Didn't like your answer on 6/10?
Slider questions!
Doing this on a '14 FXDB - what is the difference between part # 45500271 SLIDER RH FRT FORK BLACK and part # 45500273 FORK SLIDERS BLACK FXDL??? Which do I need? Is it as simple as the first part # is just the right side while the second part # is two new sliders?
My mechanic said even if I got a new black right hand slider, it would be wise to powder coat both the new right side and old left slider so that they match exactly. Is that just him trying to jack up the bill or will they be noticeably different shades of black?
Doing this on a '14 FXDB - what is the difference between part # 45500271 SLIDER RH FRT FORK BLACK and part # 45500273 FORK SLIDERS BLACK FXDL??? Which do I need? Is it as simple as the first part # is just the right side while the second part # is two new sliders?
My mechanic said even if I got a new black right hand slider, it would be wise to powder coat both the new right side and old left slider so that they match exactly. Is that just him trying to jack up the bill or will they be noticeably different shades of black?
Same Slider in Kit
BTW, that Black "Sliders Only" kit doesn't pop up @ H-D dot com currently. Only shows Chrome and both Black and Chrome in the "Full" kit
Also FWIW (for others)... besides color, I think the slight casting change was in 2012. So 2012-later looks a little different than the earlier ones.
The following users liked this post:
Jackpoticorn (10-27-2016)
#138
Touring Brembos used on 06-later Dynas will move the pads .150" outwardly on the rotor radius on the same 11.8" (300mm) rotor. That will put the pads out on the chamfered/radiused edge of the rotor or slightly past the edge
#140
If anyone looking to do this conversion is interested in a pseudo parts kit, I have this available in the classifieds: https://www.hdforums.com/forum/dyna-...49mm-dyna.html