Hey guys,
I have started my fender conversion on my 08 fat bob. I'm fitting it with the '10 wide glide fender. I dry fitted everything and everything is good to go. It is out getting painted now so all I have to now is run the wiring. I am installing the low profile tail light and after market bullet turn signals. All I was wondering is where everyone mounted the run/brake/turn signal module? On the bob fender it is tucked away and protected from water so I was wondering where all you guys tucked yours away.
Thanks for your help.

 

Why not stuff it in the frame under your seat?

 

It might be tight under there but, rearrange some stuff and make it fit. This is by far the best and safest place to put it.

 

izzyryder, do you always have the same bike? Is this 2014 recent? I thought you had a different bike.

 

Under the seat it is! Thanks fellas, I really appreciate the quick response.

 

No same bike just put a 2014 rear end on it.

 

That's what I thought lol, it's different!

 

That's where I put mine. Good luck with your install. It's pretty easy and a HUGE improvement.