Swingarm Mounted Fender Build
#161
01-03-2013 | 02:55 PM
Thread Starter
|
LOSER
Joined: May 2010
Posts: 5,719
Likes: 4
From: Williamston, NC
#168
01-04-2013 | 10:22 PM
Learned a lot, thanks for the great how to and pics!
Your bike is bad!!!
Your bike is bad!!!
__________________
TRICK!?!? From Harley- See Here
OR
TREAT from DK Custom Products ~ 10% Flash Savings on All Air Cleaners, use Code: Clean10
DKCustomProducts.com
TRICK!?!? From Harley- See Here
OR
TREAT from DK Custom Products ~ 10% Flash Savings on All Air Cleaners, use Code: Clean10
DKCustomProducts.com
#170
02-07-2013 | 11:27 AM
Road Master
Joined: Nov 2006
Posts: 1,097
Likes: 11
From: Huntley, IL
Me too. I'm on here every day.
Robbie13 you did a great job on the fender. I went the Voodoo route from Rocket Bob's. I like your fender setup but my swingarm is a 04 and doesn't have the passenger peg hardware on it. I would have to drill and tap holes into the swingarm. Don't know what that would do to the balance of the swingarm.
I did a major re-due of my FXDX and the rear fender was just one of the changes I did. I documented the whole project on another forum because Pete from Rocket Bob's is there and helped me make the Voodoo fit my 04 frame.
Rocket Bob makes a Hugger Fender. Yours looks so much stronger than his. Sorry Pete.
We need someone like you to make a kit, here in the States. I think your fender would be a plug and play set up. It would be easy for anyone to do.
Again, great fabrication.
Robbie13 you did a great job on the fender. I went the Voodoo route from Rocket Bob's. I like your fender setup but my swingarm is a 04 and doesn't have the passenger peg hardware on it. I would have to drill and tap holes into the swingarm. Don't know what that would do to the balance of the swingarm.
I did a major re-due of my FXDX and the rear fender was just one of the changes I did. I documented the whole project on another forum because Pete from Rocket Bob's is there and helped me make the Voodoo fit my 04 frame.
Rocket Bob makes a Hugger Fender. Yours looks so much stronger than his. Sorry Pete.
We need someone like you to make a kit, here in the States. I think your fender would be a plug and play set up. It would be easy for anyone to do.
Again, great fabrication.