Hey guys, Im looking at putting these: http://www.road6customs.com/online-s...oduct=13830319 on my 2012 wide glide. Will I need to change the cables to put these bars on? Also what risers do you suggest, I'm trying to go as least expensive as possible. Also pics would be great!

THANK YOU

 

OK, I was thinking some low Z's on your WG. Now that, would be smooth.

 

Hmmm, not sure what these low z's are haha,could you enlighten me?

 

low Z's are basically the bars your looking at, just a shorter rise.

 

Do you know off the top of your head if I would need new cables or wires, or would stock work just fine?

 

im not sure. i dont know what the slack is like on a wide glade.

 

You will ok on your wires an brake cable I had enough for be my 12 inch z bars ( stock that is) not sure about the other cables. Words of advice you might want to consider going with an 1 1/4 bars.

 

Thanks for the input, do you have any z bar in mind that is 8 inch rise, with 1 1/4 size

 

I have 1" bars on my 2010. Mini apes with 1.5 risers. The issue with the stock cables is the throttle. There is just not much slack there.

I believe the stock set up has a total of 8" rise. 5 at the riser and 3 at the buckhorn part of the bar.

 

i have the rsd short stacks with 1.5 risers on my 2010 and i had to add a few inches to the throttle cables