I really need some help with a sticking throttle.
#11
I just replaced the stock grips on my 2011 fat bob with the kuryakyn iso grips. The throttle side works freely until I tighten the housing, then it sticks. I mean it won't return to idle when I release it. When I hold the housing tight with my hands, the throttle is fine. It only sticks when I tighten the housing. I can't figure out where it is binding. Anyone have this problem or know how to fix it? I have adjusted the cables.
#12
I just sent my ISO grips back last week for the same problem. I looked inside the throttle grip and saw some hard glue like substance towards the end of the grip! Tried to chip it off, then said to myself, this is totally unacceptable and I am not going to try to fix their problem. I am suppose to get new ones tomorrow, I will update if I keep them - thinking about Performance Machine grips.
#14
Got my second set of Kuryakyn ISO grips today and first thing I did was look inside the throttle side grip and sure enough another glob of hard glue near the end of the grip. Not as bad as my last set but not acceptable to me, the last thing I want is a sticking throttle so I am done with these grips.
#17
Thread
Thread Starter
Forum
Replies
Last Post