Figures, right after I buy some used FXD trees so I can run t-bars, Westcoat T-Bars starts planning to make ones that are compatible with Street Bob trees.

 

Like it.... a lot !

 

Nice!! Wish they did it last month!!

 

Very cool. Where did u get that picture

 

They posted it on their FB page.

 

Those make for a very clean internally wired setup cause you can come straight out the bottom at the riser bottom half of the 1" mount!!!

 

Very nice

 

With MX bars to boot! I would get them with shorter risers, like 6" before they join into the bars that have that MX bend with the additional height, or whatever combo would get me about 8" total rise and 7" pullback.

I've done a LOT of bar and riser combinations and thinking that I finally had the ergos figured out, I still went through three more sets of T-bars!

My final and ideal measurements came out to be 8" rise, 7" pullback and 31" width. Now I don't get uncomfortable on long rides by being hunched over to reach the bars, but can sit comfortably all day long.