I did read it, I also looked at the lift but, it really doesn't matter how high you lift something if there isn't any clearance between the swingarm and the fender unless you remove the fender.

I wasn't telling you to cut the fender, just pointing out what might not be obvious.

 

I should be able to just pull the axle and lift the bike up off of the wheel. But the again the fender might wrap around to far. If not then I guess the fender will have to be pulled.

 

On post 24 is it me or is the right side of the center spike a bit off towards the tip? May be an illusion from the camera or something.

 

Good eye. I got in a hurry to lay down the paint and forgot to fix the mask. That's one of the good things about pinstripe. You will never be able to notice the slight imperfection once the pinstripe is down.

 

I got the tank striped down to bare metal and a coat of self etching primer.

 

Well, I got a little bit done to the tank this evening. Hopefully I'll get a chance to lay down the pinstripe tomorrow and then on to clear coating it.

 

I said to heck with it and went ahead and laid down the pinstripe. That black pinstripe sure does go nice with the red and silver.

 

lookin good!

 

most excellent, ghost.

that's gonna look real tight when it's all bolted back on.

are you not running a front fender?

 

I'm not running one right now. I have been looking around for a nice long one to maybe bolt on but haven't really came across the right one yet.