Home Despot and Lowes carry aluminum stock, and steel, 2" wide by 1/8" thick, easy to work with. I have made a few parts out of it and they are very sturdy.

 

Just hold your cursor over those thumbnails and the picture will load. Give it a few seconds.

 

Cowpokey, I got to your post and lost my train of thought. Your avatar is mesmerizing.... what is she saying?

 

What size are the bolts for the forward control mounts ? 3/8" ? fine or coarse threads ?

 

great job i made a set for a buddy at work that are shaped just like the harley plates and then welded on some steel tubing and we marked the tubing off and drilled holes thru it looked good then ran them thru the paint line at work for the black electra coating.

Man if my bike was blacked out id have it made at work. with the powder coat line and electra coat.

 

I know this thread is old.....

But, if you see this, can you share your measurements? Like total length, and where the bends are?

Thanks!

 

I have been thinking about making some for my 17 Low Rider

 

Bob, the last time the OP was here was in 2014. I think you're on your own...

 

I figured it was a long shot, but why not.

Later!