I use this with the ridged rack. Wife has gone on 150 mile trips on it.

 

i know its a "rigid" rack, but if you wanted to take it off...how hard is it and does it do anything to the sides of the fenders?

 

I'd go for the Dual Sundowner,& swap for the single when solo,takes about 1min if you have both fasteners.But I ride 2-up nearly all the time.

 

It's not difficult but it’s not quick either. The rack goes between the fender and the fender struts. You have to remove the 4 bolts that hold the fender in place. I also had to lift the bike to lower the rear wheel to allow the bolts to slide out. It’s best to do with a second person, a wife, gf (but not both) or kid would do. Just to hold the rack so nothing gets scratched while you’re doing the install.
I preferred this rack over any other. I had a Motherwell on for less than a week before selling it and installing this one. The quick detachable items are nice, but I didn’t care for the appearance of the additional hardware that is needed to make it all work. This rack looks very clean, and you could stand on it if you wanted.
R

 

Hey dude,

I think I already told you about Le Pera seats via PM. They have some that apparently preserve the smooth lines of the bike and can ride 2-up (not for long trips tho as I have been told).

When I will get my Bob I will definitely look at Le Pera they have some very nice looking seats.