new rush slip om mufflers
#1
new rush slip om mufflers
my brother and i just put new rush on slip on mufflers on his 2010 wide glide very was to do . one thing we notice the top mufflers is leaking bye the bottom is fine we did put new clamps on.......bye riding the bike will the mufflers heat up and seat.....maybe somebody here knows my brother thanks you people*****
#3
#6
I've found it best to just throw out all of the rules of proper English when reading posts on this forum!
As for KOJAX' question - SFG has a great point. The clamps won't make a good seal if you don't have the muffler pushed far enough up the head pipe. If you still can't get a good seal, you can use a high-temp (copper) RTV compound to get a good seal.
#7
Really Vic, 'bye' is the only grammatical error you found to pick on?
I've found it best to just throw out all of the rules of proper English when reading posts on this forum!
As for KOJAX' question - SFG has a great point. The clamps won't make a good seal if you don't have the muffler pushed far enough up the head pipe. If you still can't get a good seal, you can use a high-temp (copper) RTV compound to get a good seal.
I've found it best to just throw out all of the rules of proper English when reading posts on this forum!
As for KOJAX' question - SFG has a great point. The clamps won't make a good seal if you don't have the muffler pushed far enough up the head pipe. If you still can't get a good seal, you can use a high-temp (copper) RTV compound to get a good seal.
Trending Topics
#8
And, as a Wise Man once said;
"It's a damn poor mind that can only think of one way to spell a word."
--Andrew Jackson
#9
Make sure the clamp is positioned correctly on the muffler. The hard piece shouldn't be over a gap in the end. Then tighten down, back off 1/4 turn and retighten. do this a few time's. It will pull everything together properly. All the other post are correct make sure they are all the way up on the head pipe and the clamps aren't to far down (are not far enough) on the mufflers. You might have to try tightening a few times to get the perfect fit. Good luck.
#10