Just got a set of Screamin Eagle 10mm plug wires (Red). I'm a little surprised (and a lot not surprised) that they didn't come with a replacement retension clip (the plastic piece that holds the wires together near the coil). Also, there are no horn bracket clips to hold the front wire to the horn bracket.

I haven't been out to the bike yet but I believe these wires are fatter than stock so I'm not sure if the retension clip will fit the new wires. And I have the same concern about the horn clips if they are even reusable.

Anyone replaced their wires with these and dealt with this? Do I improvise or do I need more parts?

 

I did ... I just bought a set of extra wire/zip tie clips for 50 cents a piece.




Greg

 

Zip ties work too.

 

It's like duct tape for mechanics!

 

my stock clip does not fit. Don't need it either. zip tie the front wire to the horn mount.

 

Like everyone else I just zip tied the front one to the horn bracket.

 

Yep, got it - thanks. Fatter wires definitely don't need the retension clip and a zip tie on the horn bracket got the job done. Just wanted to be sure there weren't some proper parts I should be using.

 

I bought red zip ties and got a little creative with some clips designed to be used with the zip ties.

 

Anyone find any increased performance with these wires, or are they just for looks? I'm thinking about a set myself.

 

I just bought them to add a little sporty color to that side.

And because bberck has them. LOL j/k!! Didn't even know he had them until he replied to this thread.