So far, so good. Between the fairing and hand guards, these 34 degree mornings are more tolerable. It take a lot of the wind off my chest.

 

Fairing looks really good, SLV. I like how you kept it black around the headlamp.

 

I have another question for you guys that maybe you can answer without me pulling my hair out trying to make something fit that doesn't.

I have an original ness 1/4 fairing and it came with two brackets which will not fit around my forks without bending them quite a bit. After searching it seems they may not be the correct brackets and I'll have to find make my own.

The second part of this question is about the headlight. My 99 Fxdx has a light with the visor on it that mounts to the top of the triple tree with two bolts. The relocation kit that ness sells seems to be for lights that mount to the center with one bolt.

I'm guessing that there are brackets and a relocation kit for the headlight to make this a whole lot easier.

 

Hi,

A lot (at least a few) of you guys are running exhausts that looks alot like this one in the attached picture. It is a Victory running an exhaust that I think looks very good, would want to know which one it is and if it is (probably) a version for Dynas. Just wonder if it is a Bassani, a DD or something else completely?

 

Whichever it is, looks like a bassani, but even if it isnt, i'd still get the bassani, great exhaust

 

the kit you are describing is for a 2006-up dyna with a bottom tree mounted headlight and 49mm fork tubes. You have 39mm tubes if your dyna/fxr is 2005-down. You will need to make your own brackets or get creative. Use the search function on here and it should return a plentiful supply of mounting threads. My suggestion to you would be to get a newer style headlamp and just drill a 3/8 hole in your bottom tree for the mounting bolt. That squares away your healight bracket. Then get some 39mm turn signal relocation brackets off of ebay. Take some flat stock and bend it to fit. Brackets done

 

Might be this one from a different angle: http://www.bassani.com/part/6H22RB

 

If you have the aluminum block with two holes in it for the headlight , one bolt will go in the factory hat. Your headlight will bolt through the other hole. As far as the brackets go. Are you saying they are smaller diameter then your tubes? If so you have the brackets for a 35mm. There is a thousand ways to mount them. I can pm you some pics of my brackets after I get finished assembling all this stuff Santa left

 

Yes the brackets are too small for the 39mm forks.

Pictures of the setup would be great from the back so I can see how you guys rigged it up

 

If you look close at the photo of the exhaust. It has a V&H pro pipe collector.
The can looks like a Bassani.

I am considering going to the larger forks so I can fit a larger front tire.