Does the fat bob tank fit the SB? Much easier to find a used FB than a SB.

THanks
LRB

I think I saw the answer sometime in the past but I can't find it

 

The tank will fit the frame BUT, the console, top plate & speedo among other things are different.

 

You can make it work.....

 

Get a bigger hammer...

 

You can make any thing work. I got a Wide Glide tank & fender package about a year ago and I've been collecting parts. So far i've got

Zanotti HD
Fuel Cap P/N 61272-92B .......................... $19.51
Fuel Gauge P/N 75053-01B ........................ $61.54
Top Plate P/N 75217-04 .......................... $40.52
Instrument Consloe P/N 71211-04 ................. $91.48
Dash light assyembly P/N 68113-99B .............. $27.75
$240.80 + $17.27 S&H = $258.07

Chicago HD
Top Plate Seal P/N 75249-04 ..................... $14.40 Surdyke & Chicago
Trim, instrument panel P/N 71279-04 ............. $8.00 MSRP /$6.40 Chicago/
Bezel P/N 69538-04A ............................. $11.20 MSRP/$8.96 Chicago/
Guage Clamp P/N 67271-04A ....................... $4.00 Chicago
Seal/Speedometer P/N 67190-89 ................... $11.50 MSRP/$9.20 Chicago/
Switch Assy Trip Set P/N 67565-04 ............... $11.60 Surdyke & Chicago
Spun Aluminum Face Speedo P/N 67313-05A ......... $159.96
$214.52 + $13.50 = Total: $228.02

 

Skip - I'm trying to get a 2008 fat bob tank on my FXD (2007).
Did you finally get yours rigged up?
Anything I should look out for?
Were you able to use anything from your FXD (fuel pump)?
Cheers.

 

Keep in mind the fat bob tank is about 1.5" wider than the street bob tank, so it will be a different look.

 

Thanks, yes, be good to have a little extra gas and a little different look too!

One thing I noticed, there is an extra tube "nub" under the bob tank that the FXD doesnt have. Is it for the vent tube?

 

the fat bob tank is the same as the Softail's right?

 

That is were the fuel gauge wire runs out.