Sissy bar and tbag complete....

 

hi,

beautiful fella's, well done, anything on a 2010+ wide glide is sweat

thanks
mirrmu

 

Nice. Getting ready to go to Nationals?

 

had to change it up a bit I did take off the chrome covers so they can always go back on I did not wrap on top of them. Whatcha think

Before


After

 

I wish, don't have the PTO to go, but am going up to Colorado to the Catholic School Girl poker run.

 

I need to take a trip to Colorado this year. It's been too many years since I've been there. Hope you come to nationals next year, it's in KC so it's not too far of a ride, at least not for me.

 

Cool, I will have to see if I can make that one. I haven't spent much time since I lived there back in the day...

 

To all of you who have changed the rear blinkers to any after market model that need you to replace it with a screw instead of the stem of the OEM blinker;

What kind of screw did you use? The same one as the front screw that goes through the struts and strut covers is too short. I have tried screws from a Fat Bob which are longer than the Wide Glide but it is not long enough.

Now the guy that did some work on mine put in a longer one in the back in chrome and with a non-matching screw head, it does not look good. So I am looking for preferably an "original" screw that is long enough (is there any H-D model that has this?) or an eBay link or something to screws that I can change both the front and rear strut screws to get them matching in stainless.

 

Vance and Hines Fuelpak FP3 going in today...

 

Super easy install and popping is totally gone with a bit of an increase in throttle response and power all through the rpm range...recommended!