Cut back fender on your Street Bob?
#1
Cut back fender on your Street Bob?
Has anyone out there cut back their fender just a little bit?
I want to keep the stock tail light position, but expose a little more of my fat 180 rear tire. I was thinking of cutting back about 1-2 inches. My question is will it be worth the trouble and the little bit of touch-up paint to finish the cut edge?
The previous owner had a dumb license plate holder attached to the bottom of the fender. I was going to cut just above the holes he left there.
Since this picture I have added a Kuryakin clear laydown LED tail light.
I want to keep the stock tail light position, but expose a little more of my fat 180 rear tire. I was thinking of cutting back about 1-2 inches. My question is will it be worth the trouble and the little bit of touch-up paint to finish the cut edge?
The previous owner had a dumb license plate holder attached to the bottom of the fender. I was going to cut just above the holes he left there.
Since this picture I have added a Kuryakin clear laydown LED tail light.
#4
Thread
Thread Starter
Forum
Replies
Last Post