I'm STUPID...Don't make this mistake!!!
#12
11-09-2008, 02:00 PM
Join Date: Jul 2008
Location:
Posts: 890
Likes: 0
Received 0 Likes
on
0 Posts
Welp...alls well that ends well... sort of.
I was able to FINALLY get the QB's out. That was the biggest struggle of my "wrenching" history.
There was a couple of minor dings at the ends of the pipes but they aren't noticable from more than a couple of inches away. Got the original baffles back in and I AM KEEPING IT THAT WAY!!!! hahahahaahahaaa
I was able to FINALLY get the QB's out. That was the biggest struggle of my "wrenching" history.
There was a couple of minor dings at the ends of the pipes but they aren't noticable from more than a couple of inches away. Got the original baffles back in and I AM KEEPING IT THAT WAY!!!! hahahahaahahaaa
#13
11-09-2008, 04:51 PM
Road Master
#15
11-10-2008, 07:42 AM
Join Date: Jul 2008
Location:
Posts: 890
Likes: 0
Received 0 Likes
on
0 Posts
Liquid Wrench....heated the pipes...more Liquid Wrench...Little by Little by Little By Little....
At one point I had to wrap a Coat hanger around one of them at the Bolt Hole and used a Huge Hammer to "Whack it out"!!!
Be advised....The Fiberglass wrap can make it...uh... DIFFICULT to remove these bastards!
At one point I had to wrap a Coat hanger around one of them at the Bolt Hole and used a Huge Hammer to "Whack it out"!!!
Be advised....The Fiberglass wrap can make it...uh... DIFFICULT to remove these bastards!
Thread
Thread Starter
Forum
Replies
Last Post