Internally wiring z bars, Need Help, tips or advice welcome.
#1
#3
Join Date: Mar 2007
Location: Chicago suburbs (Elgin/Schaumburg)
Posts: 19,481
Likes: 0
Received 25 Likes
on
23 Posts
RE: Internally wiring z bars, Need Help, tips or advice welcome.
blow fishing line though with an air compressor, then pull a thicker string though with that, z bars in the past i have had to pull 1 wire at a time, you can do this by feeding 1 fishing line with 8 tied to it, pull 1 at a time
#4
#5
RE: Internally wiring z bars, Need Help, tips or advice welcome.
I don't know what you are using to pull them through (fishing line -wire- plastic-etc) but try wrapping the joint between the wiring and whatever with teflon tape and if it is still too hard, spray with silicone spray. Sometimes doing them one at a time is the fastest way.
#6
RE: Internally wiring z bars, Need Help, tips or advice welcome.
I just got done doing my Z-Bars they were a PAIN IN THE ACE!!!!!!
One at a time and be careful, I got a little skippy with pulling one that was getting stuck, and stripped the insulation off the side of the wire. Had to pull it and start over. [:@]
One at a time and be careful, I got a little skippy with pulling one that was getting stuck, and stripped the insulation off the side of the wire. Had to pull it and start over. [:@]
#7
Trending Topics
#8
#10