Pretty much the baddest bike ever!!
#22
![Default](https://www.hdforums.com/forum/images/icons/icon1.gif)
ORIGINAL: stagolee
May just clean his colon.
ORIGINAL: jefx
If you ever get rear-ended they will do some extra scrotal damage as well.
ORIGINAL: Elginator
Hang on tightwhen you goose the throttle.It might hurtif you slid backwards off that low line saddle of yours.
Hang on tightwhen you goose the throttle.It might hurtif you slid backwards off that low line saddle of yours.
![Wink](https://www.hdforums.com/forum/images/smilies/wink.gif)
![Big Grin](https://www.hdforums.com/forum/images/smilies/biggrin.gif)
![Big Grin](https://www.hdforums.com/forum/images/smilies/biggrin.gif)
#26
![Default](https://www.hdforums.com/forum/images/icons/icon1.gif)
ORIGINAL: low06
Man that looks good. Where'd you get the lay down plate holder?
Man that looks good. Where'd you get the lay down plate holder?
http://www.kuryakyn.com/products.asp...ey&ci=3518
Rick
#27
![Default](https://www.hdforums.com/forum/images/icons/icon1.gif)
ORIGINAL: CSA
Looks Good Rick!
Hey dude what length Risers do you have on your bike? I have 4 inch and they are just to short. I have been thinking about going higher. Yours look just about right!
Looks Good Rick!
Hey dude what length Risers do you have on your bike? I have 4 inch and they are just to short. I have been thinking about going higher. Yours look just about right!
Heres the link to their site:
http://www.wild1inc.com/
Rick
#28
#29
![Default](https://www.hdforums.com/forum/images/icons/icon1.gif)
Your askin alot flynavy j/k. It is a C&C seat... pretty sure they are a sponser here. It was about $200 and I rode from my home in the lower part of NY to Montreal Canada and it was fine. A little stiffer than stock but no problems. The only complaint is the pan was not cast perfectly which left the tab a little high in the back... as in the tab had to be mashed into the fender with the mounting screw putting stress on the rivets... eventually pulling them out. My pops drilled in new ones for me (THANKS DAD) and I took a belt sander to the back to get a better fit... Now its much better... ANYWAYS... heres the link.
www.ccseats.com
Rick
www.ccseats.com
Rick
#30