Hi,

I want to replace the derby cover of my SB 2008 (alu) with a NT derby cover (wrinkle black) but i don't find it's ref part anywhere...

Any clue?

 

I don't have the part # either but calling the dealer will do it for you. If you get it, remember to get the replacement gasket that is flat because you have an o-ring one on yours that won't work with the wrinkle black derby cover.

 

Here it is 60713-07

I use the derby cover on my -08 and you don't need the flat gasket.. reuse your "old" silicon ring.

//K

 

Thanks a lot for your fast answer but i'm afraid my dealer will not be very cooperative... Here, in France, parts are very expensive and lot of us buy in US web sites (M&M or Discountbiker, for example)... So dealers don't like give us ref parts...

Ok, i note this precious tip.

 

Cool, thanks A LOT

 

oops! Sorry; didn't know you were in France.....I would have made the call for you but I see it has been answered.

And I stand corrected on the derby cover. As long as it has the o-ring inset you'll be fine.

 

The Derby cover 60713-07 is for Night Train -07 up and all -07 upbig twinshave the "ring".

Just to calm jaco

//K

 

BTW: do you know the ref part of this ring ? (just in cas mine would not be reuseable) ?

Or, at least, some URL where i can find mylsef this information?

 

I'm afraid no, I reused mine and didn't botter to get the part no.

 

I cant be of too much help either, but I just got done doing this, and it took all of two minutes to complete. Simple as pie! Just have a buddy hold the bike at an angle away from the cover as to not spill the oil. Back to the issue, the silicone ring is from the 1k mile service kit, and comes with three little O-rings that you wont need, but it has a new red ring that doesnt hurt to use a new one. At least here in the states it only costs a dollar something, up to you. Best of luck!