indicator lights.what to do.
#11
01-26-2006 | 12:39 PM
Road Warrior
Joined: Dec 2005
Posts: 1,950
Likes: 1
From: Colorado Springs, CO
RE: indicator lights.what to do.
1. Mount a small LED in the back of your turn signal housing, wired to the lamp plug.
2. For the high beam indicator, put a small LED in the top rear of the lamp housing.
3. Get rid of the idiot light and use an oil pressure gauge.
4. That leaves the neutral indicator light and the check engine light. Again, use LED's and mount them in the dash or headlamp housing.
2. For the high beam indicator, put a small LED in the top rear of the lamp housing.
3. Get rid of the idiot light and use an oil pressure gauge.
4. That leaves the neutral indicator light and the check engine light. Again, use LED's and mount them in the dash or headlamp housing.
#12
01-26-2006 | 06:47 PM
Thread Starter
|
Tourer
Joined: Dec 2005
Posts: 335
Likes: 12
From:
RE: indicator lights.what to do.
ORIGINAL: bobcowan
1. Mount a small LED in the back of your turn signal housing, wired to the lamp plug.
2. For the high beam indicator, put a small LED in the top rear of the lamp housing.
3. Get rid of the idiot light and use an oil pressure gauge.
4. That leaves the neutral indicator light and the check engine light. Again, use LED's and mount them in the dash or headlamp housing.
1. Mount a small LED in the back of your turn signal housing, wired to the lamp plug.
2. For the high beam indicator, put a small LED in the top rear of the lamp housing.
3. Get rid of the idiot light and use an oil pressure gauge.
4. That leaves the neutral indicator light and the check engine light. Again, use LED's and mount them in the dash or headlamp housing.
jay.
Thread
Thread Starter
Forum
Replies
Last Post
