What did you do to your Dyna today? ** Part 2 **
#141
Well, took out the main fuse, pulled all the rest to check them and none are blown, re-sat the battery terminals, and then it started up fine. I noticed when I pulled the fuses that there was no dielectric grease on them and certainly some corrosion building up. Think I should replace all the fuses and use some dielectric?
#142
#143
Swingarm project
Been chipping away every day before work. Got the swingarm pivot shaft nut off today. That bugger was basically seized on. I had about 1/8-3/16 of play in the swingarm. Crazy the bike even went down the road. I've decided to do front and rear motor mounts while the bike is down. I don't want to end up doing them in the middle of summer.
The following 4 users liked this post by Dynawobble:
Garage Queen Rescue (02-22-2024),
snake_eyes (02-22-2024),
the_huber_show (02-23-2024),
Tom H (02-22-2024)
#144
The following users liked this post:
Dynawobble (02-23-2024)
The following 5 users liked this post by snake_eyes:
Dynawobble (02-23-2024),
Garage Queen Rescue (02-23-2024),
mte78 (02-23-2024),
the_huber_show (02-26-2024),
Tom H (02-23-2024)
#146
The following users liked this post:
snake_eyes (02-23-2024)
#147
#148
The following users liked this post:
snake_eyes (02-23-2024)
#150
Clearenced the transmission
Well I clearanced the transmission for the Brocks swingarm today. Not my best work by any means. I nicked the trapdoor cover but a little bit of flat black touch up paint should do. (Shakes head aggressively) Waiting on motor mounts to show up from revzilla and then I'll assemble it. No point in mounting the swingarm before the motor mount.
The following 5 users liked this post by Dynawobble:
Garage Queen Rescue (02-24-2024),
mte78 (02-24-2024),
snake_eyes (02-24-2024),
the_huber_show (02-26-2024),
Uncle 'B' (02-24-2024)