I bought the front 4825 kit from Eastern Performance on ebay and got them in three days. they have super fast shipping and great prices. I got them installed in less than 15 minutes which included wiring in the resister on the main harness under the seat. the lights flashed normal with just the rear kit installed but after installing the front kit I had to install the resister kit. I'll take a few shots tomarrow after work and post them. I am very pleased with Kuryakyn'squality and finish, the lighting on my bike turned out great.

 

Very sharp!

 

Ihad one question? whats the threelittle black dots on the fender just above the tail light? is if from the old liscense plate bracket?

 

That Looks Great.


ONE QUESTION FOR ANYBODY: Does the Lisence plate holder need a light? Is it necessary? Can you expect to get Ticketed if you do not?

 

Thanks to this post I'll be ordering the sidemount plate kit as well as a license plate mounting hole cover for the fender until I decide whether or not to fill and paint the holes. I already ordered the smoked LED taillight.

Thanks for the pics and the post!!!

 

Yes the holes are from removing the original license plate bracket. I went up to the dealership and they had the plugs in stock for 23cents each.

 

Most states require a license plate light, the Kuryakyn curved sidemount I installed has six small white led's built into the side. I wired it into the main harness under the seat. you can see the light they put out in the picture below.

 

I have one. Didn't really like the look on my bike. Only a month old, the only thing is you would need to make a new foam gasket. They are around $170 new. I would sell it for $100 including shipping. If you intrested PM me.

 

Here is a picture of the fronts installed.

 

Tell you what SB, get your bike done the way you want it, and sell it to me. I think were on the same page man! They look great, and thanks for all your help!