I ground and drilled out the rivits,reversed the mount and used button head bolts to secure the forward fender hole to the rear hole on the mount. This will hold the fender and I used a plug to fill the rear fender hole. Then mount the fender using the bottom hole on the fender tabs on the slider and rotate the fender into position and redrill the upper hole on the fender mount through the tab on the slider. Only cost is chrome bolts and nuts to replace the factory bolts on the slider,if you want to do that.

Good Luck

Tom

 

The grips are Harley heated grips,the black levers are from Rudedog here on the forum,rest is stock.

Good Luck

Tom

 

The grips are Harley heated grips,the black levers are from Rudedog here on the forum,rest is stock

Good Luck

Tom

 

Corbin solo with matching pillion.

Good Luck

Tom

 

Hi Ronn,good to hear from you. I've always admired your bike,when I redo mine again I might go with the look you have on your bike including the floorboards.

Got the h-lite bracket from Dennis Kirk,don't have the part number with me,my computer is down at home,I'll post it later. I got the part number on here but I can't remember who posted it.

Good Luck

Tom

 

Think I can help - got my head light mount from Dennis Kirk as well. Part Number is H22-139 and is made by Headwinds, $38 + shipping.

Chip

 

Thanks TOMMAY for the kind words.. I've always felt the FXDBI headlight was set back a little too much.. Looks good on you and Chips ride.....
Chip thanks for the part numbers...........
Ronn

 

I used the same bracket for my headlight.
Bike is looking good Tommay

 

Looks Great TOMMAY !! I alwaysfind it interesting to see what you've donecause I've seen your bike in person.I tooneed that headlight blockpart # ... that's next on my list.
Hope all is well down your way !!

PsTaN

 

Hi Tommay,

Great looking bike!

I've been searching all over for the headlight bezel that you have. Is this an HD part aftermarket?

Thanks!