so today i was polishing my rear wheel i set it down heard a noise
and checked it out the left axle bearing and spacer just fell out on the floor
this is not normal is it?
is there a fix for it if not normal

 

You kidding - right

Where was the axle / axle nut / c-clamp - when the bearing / spacer were falling onto the floor

The fix is - put it all back together - but check that the bearing is good first

Ghost

 

Wheel is off the bike

 

Wheel bearings should not fall out - when removing / installing..., it needs to be pressed in/ out (iow it a tight fit)


So

Is it the correct bearing for the wheel

Is the hub wallowed out - and needs replaced

You have calipers that you can take some measurements

Ghost

 

That's not normal those buggers are pressed in and very hard to remove without a proper tool guess you need to take it to indy or HD shop to get it fix right.

 

Sorry but unless you was cleaning your wheel in a freezer a -40 that bearing should not fall out, does not sound like it was the correct bearing to start with as the ops have said above.

 

so the bearing spun in the hub no need to use calipers i cleaned it up and can see the groove that the outer case left in the hub

so my question is does anyone know where to purchase a replacement OEM mag
wheel for a 2010 fxd

 

Well you can either go to a machine shop, and see what they say, or get a bearing shim.

https://www.mcmaster.com/#bearing-shim-rings/=icvtu1

 

Try Ebay....p/n is 40987-08
Bearing p/n is 9276, I.D. 25mm

 

You probably don't need a new wheel. Try some Loctite Bearing Retaining Compound.

http://www.machinebuilding.net/ta/t0418.htm

Several versions are offered, 660, 680 etc. It's easy to find at auto parts stores, Amazon and elsewhere.

This is an adhesive that can hold the race of a loose bearing in its bore.

http://na.henkel-adhesives.com/indus...ound-14963.htm


Other brands are also out there.

Also, I'd replace all the wheel bearings. H-D has been using some cheapo bearings in recent years. Buy a name-brand like Fafnir/Timken etc.

If you do a search, you'll find an old thread where I gave more info and part numbers.

Your bearing probably went bad, locked up and spun in its bore. You should be able to fix this just fine.

edit- here ya go. Read this old thread. H-D changed sizes on some of these wheels so double check part numbers to make sure for your year model.

https://www.hdforums.com/forum/dyna-...el-wobble.html

.

.