2016 FXDF Fat Bob front turn signal relocation issue
#1
2016 FXDF Fat Bob front turn signal relocation issue
Hey guys. I know what you're going to say.... have you searched for this answer in the forums? The answer is yes.
So, I have a 2016 FXDF Fat Bob and I purchased a new Memphis Shades Batwing fairing for it. As you know, you need to relocate the front turn signals to install this fairing. I purchased a cheap relocation kit off eBay that should do the job, but when I tried to move the turn signals today, I don't see how to separate the wiring for the turn signals from everything else. It looks like all the wiring is routed through the handlebars in one wire loom, and with other Dynas, I noticed that the wiring for the turn signals was separate and secured with zip ties to the outside of the handle bars.
Here's my question - How can I relocate the turn signals without cutting the wiring?
Turn signal relocation issue on 2016 FXDF Fat Bob
#3
#4
The following users liked this post:
sgrever (05-24-2017)
#5
#6
#7
Trending Topics
#8
#9
#10
I have been wondering the same thing eventually I want to change my mirrors to LED signal mirrors....if you have to cut and splice, soldering followed with a heat shrink wrap is pretty dependable.....small gauge wire is not hard to solder.....if you want to avoid soldering, take a look at these connectors
I have used them many times.. https://www.posi-products.com/
and also these http://www.wago.com/221/us/?_ga=2.14...241.1495731197
Both can be bought on Amazon
Good luck!!
I have used them many times.. https://www.posi-products.com/
and also these http://www.wago.com/221/us/?_ga=2.14...241.1495731197
Both can be bought on Amazon
Good luck!!
The following users liked this post:
sgrever (05-25-2017)