Before and current pictures of your Dyna
The following 2 users liked this post by union53:
johnnynitro (08-20-2019),
Krash26 (08-22-2019)
#83
Day I brought her home
Didn't like those bags and seat. Dropped with Burley front and rear springs and shocks.
Got rid of the football and added DK 587 with external breather
Added black spoke wraps, hard wired GPS , and phone to bars
New Fairing Bags and seats
Current with more to come
Last edited by Tileman2692; 08-20-2019 at 09:34 AM.
#84
This is rad. Only picture I took the day I got it:
A few weeks back lost on a dirt road:
Been catching up on needed maintenance stuff (motor mounts etc). Top of my priority list is some bags (getting tired of stuffing stuff behind my fairing or travelling with nothing), more black, more torque.
A few weeks back lost on a dirt road:
Been catching up on needed maintenance stuff (motor mounts etc). Top of my priority list is some bags (getting tired of stuffing stuff behind my fairing or travelling with nothing), more black, more torque.
#87
The following 9 users liked this post by checkster2000:
amit (08-23-2019),
Antonio Balls (08-22-2019),
Buratina (03-24-2020),
johnnynitro (08-22-2019),
Krash26 (08-22-2019),
and 4 others liked this post.
#88
The sissy bar is the "Hell Bent" bar from Ginz Choppers. Mine is the "monolith" length which at it's peek is 29 inches off the fender. They no longer offer that length. The tallest is the xtreme which is 25 inches tall but if you wanted higher I have a feeling you could talk them into it. They are pretty good with custom stuff but you'll pay for it. I opted for the detachable version and I think their system is much nicer then most. No giant side plates.
The pad is a combination of me and Sick Saddles. Sick Saddles made my seat and pad so when I came up with my back pad idea I had them upholster it for me. I made the backing from 1/4 inch high density plastic and then its held on by integrated well nuts and 1/2 inch emt clamps.
The pad is a combination of me and Sick Saddles. Sick Saddles made my seat and pad so when I came up with my back pad idea I had them upholster it for me. I made the backing from 1/4 inch high density plastic and then its held on by integrated well nuts and 1/2 inch emt clamps.
#89
I've upgraded it more since those pictures were taken....
The bars I bought locally at a swap meet, I got two sets cheap.
The tank is from an '83 FXR, The fully functional FXDXT repop fairing is from Deviant Fabrications.
The following users liked this post:
Dirtbandit (04-18-2022)
#90
The following 2 users liked this post by damo14:
Marty_307 (07-17-2021),
snake_eyes (11-15-2019)