Air Suspension on Dyna
#31
Join Date: Mar 2007
Location: Chicago suburbs (Elgin/Schaumburg)
Posts: 19,481
Likes: 0
Received 25 Likes
on
23 Posts
i dont know about that... i woudl say the DIY kit looks pretty good when done right
https://www.hdforums.com/forum/dyna-...ride-done.html
my switch/guage set up
compressor mount
compressor all gone
https://www.hdforums.com/forum/dyna-...ride-done.html
my switch/guage set up
compressor mount
compressor all gone
#33
The compressor is in the leather bag at the bottom of the down tubes. The dump valve is under the seat and the switch is on the back of the electronics box on the left side of the bike. I also built a gauge pod for the pressure gauge that is connected to the coil cover. I highly recommend this switch. http://www.amazon.com/Cole-Hersee-55...iglink20376-20 It stays on in the up direction so you can flip the switch while putting your helmet on and it will be good to go. Then it is only momentary in the down direction to let air out of the system. I burned up a dump valve when I left the switch on before I bought that switch.
switch
gauge pod
gauge
switch
gauge pod
gauge
#34
Thanks. They are shinko 777's in the stock sizes. I got them on amazon. There was a thread no that long ago that showed the best prices and places that had them in stock.
https://www.hdforums.com/forum/dyna-...nko-777-s.html
https://www.hdforums.com/forum/dyna-...nko-777-s.html
Last edited by Ninety8NeonACR; 01-30-2015 at 05:26 PM. Reason: Added link
Thread
Thread Starter
Forum
Replies
Last Post