What did you do to your Dyna today?
#9341
04-17-2018 | 11:33 PM
Seasoned HDF Member
Joined: Jan 2015
Posts: 14,957
Likes: 5,808
From: Sandy Eggo's North County
can't wait for the first start video and the dyno...
we'll see if you can top this face:
https://www.youtube.com/watch?time_c...&v=73pnBu4nll8
we'll see if you can top this face:
https://www.youtube.com/watch?time_c...&v=73pnBu4nll8
#9342
04-18-2018 | 12:14 AM
Club Member
Joined: Mar 2016
Posts: 11,386
Likes: 17,762
From: Clearwater, Idaho
I'll probably get it installed tomorrow. Had about enough for one day. Time for a cold one...
Mmmmm... Homebrewed American Pale Ale....
Last edited by martinj; 04-18-2018 at 12:18 AM.
The following users liked this post:
ludville1 (04-18-2018)
#9343
04-18-2018 | 09:07 AM
Grand HDF Member
Joined: Jun 2013
Posts: 4,977
Likes: 734
From: Iowa
It didn't happen without pics!
The following users liked this post:
mirrmu (04-20-2018)
#9345
04-18-2018 | 10:03 AM
Tourer
Joined: Oct 2017
Posts: 300
Likes: 45
From: Calgary
Originally Posted by atomicdyna83
Lol, fair enough. Don’t mind the nasty grey Nissan in the background.
#9346
04-18-2018 | 11:03 AM
Advanced
Joined: Sep 2017
Posts: 93
Likes: 16
From: Oklahoma
It was quite a PIA. My heat gun took a crap on me so I was stuck using the wife’s high dollar hair dryer (shhhh. Don’t tell her). And even though the hair dryer got much hotter than I expected, it was just about impossible to keep the emblem itself from separating from the foam in between it and the tank. It ended up coming down to lots and lots of elbow grease, rags, and goo gone. I just wasn’t able to get the adhesive hot enough to get it to peel off completely.
#9347
04-18-2018 | 11:41 AM
Road Warrior
Joined: Jun 2017
Posts: 1,705
Likes: 1,014
From: Lawrenceville Ga.
I use plain mineral spirits and it melts the glue easily, Just wash and wax afterward .
Another trick is to use new plastic bondo spreaders, one to lift and one on opposite side to keep emblem from touching paint.
Another trick is to use new plastic bondo spreaders, one to lift and one on opposite side to keep emblem from touching paint.
#9348
04-18-2018 | 01:48 PM
Cruiser
Joined: Jun 2014
Posts: 234
Likes: 45
From: Spain
It was quite a PIA. My heat gun took a crap on me so I was stuck using the wife’s high dollar hair dryer (shhhh. Don’t tell her). And even though the hair dryer got much hotter than I expected, it was just about impossible to keep the emblem itself from separating from the foam in between it and the tank. It ended up coming down to lots and lots of elbow grease, rags, and goo gone. I just wasn’t able to get the adhesive hot enough to get it to peel off completely.
#9350
04-18-2018 | 03:08 PM
Grand HDF Member
Joined: Jun 2013
Posts: 4,977
Likes: 734
From: Iowa
I used fishing line.