Dyna Glide ModelsSuper Glide, Super Glide Sport, Super Glide Custom, Dyna Glide Convertible, Super Glide T-Sport, Dyna Glide Police, Dyna Switchback, Low Rider, Street Bob, Fat Bob and Wide Glide.
H
I shaved the rear turn signals,6” accutronics risers that I paid twenty bucks for DONT call the cops because I stole them.lowered it 1-1/2” made a indicator light bracket out of the 2” tank lift I took off,new cables, brakes, 3 hole change,plugs,wires,head light,lay down plate,lower belt guard made a swing arm bag mount .and a whole lot of polishing.
H
I shaved the rear turn signals,6” accutronics risers that I paid twenty bucks for DONT call the cops because I stole them.lowered it 1-1/2” made a indicator light bracket out of the 2” tank lift I took off,new cables, brakes, 3 hole change,plugs,wires,head light,lay down plate,lower belt guard made a swing arm bag mount .and a whole lot of polishing.
Finally became a Dyna owner again today. Been looking around lately, and decided on this one. A '12 FLD, with 7400 miles. Stock, no Stage 1 parts. Came with the Harley Boom Sound System, and I added a Sundowner I kept from my last Dyna. Has a windshield and a QD Sissy Bar/rack combo too.
Cool and rainy today, so only rode around 10 miles, just to make sure it would feel as expected, and it passed with flying colors. Glad to be back on a Dyna, seeing that will no more of them made... tp
Got some more done on my 110+ project .............
Grinding the seats (multiple angles)
Re-facing the valves
Checking the spring tension at the measured installed height as well as at full lift
checking installed height
Had to make a valve seal installed
newly made tool !
Checking valve travel & seal clearance
Good to go
Mmm , dry film coated pushrod tubes
Had to make a seal driver , hmm , a tool I didn`t have . Heads are on , moving ahead with finishing it up . I need to look and see if I can find a S.E.P.S.T. map that will work for me.
Got some more done on my 110+ project .............
Grinding the seats (multiple angles)
Re-facing the valves
Checking the spring tension at the measured installed height as well as at full lift
checking installed height
Had to make a valve seal installed
newly made tool !
Checking valve travel & seal clearance
Good to go
Mmm , dry film coated pushrod tubes
Had to make a seal driver , hmm , a tool I didn`t have . Heads are on , moving ahead with finishing it up . I need to look and see if I can find a S.E.P.S.T. map that will work for me.
Nice work, and a nicely equipped shop. Just curious, what cams?
Nice work, and a nicely equipped shop. Just curious, what cams?
Thank`s , 45 years of riding and wrenching for a living and being a tradesman since high school.
I`m using a Screamin-Eagle kit for the 110 engines , comes with 259E cams , perfect fit pushrods , high compression Mahle pistons , gaskets and a clutch spring which I think is not the correct spring for this bike , I`ll know tomorrow when I look inside the clutch cover. I tweaked the heads , added a 58mm throttle body and my own hand crafted air cleaner.
02-03-2018, 04:28 PM
What I did to my low rider over the last week
