What did you do to your Dyna today?
#8011
Finally got the Brembo calipers and pads in. Fitted them up and mounted with ARP 12 point stainless bolts. Also got the Magnum Shielding Black Pearl ABS block and lower brake lines installed. I also used an ARP bolt to mount the ABS block. ARP is the only way to go when replacing fasteners IMHO. The Magnum Shielding stuff is really nice kit! The iPhone pics don’t do it any justice.
#8012
Thanks! I’m really liking the way this build is going. The calipers are Brembo M4s. They are 108mm radial mount.
#8017
Not sure who that was directed toward, but there are several models with dual disc fronts. The RH fork sliders are unique to those models. Depending on what year & model you have, the swap can vary in complexity.
The following users liked this post:
Tall Timber (11-05-2017)
#8019
I found mine at the dealer, on a 2016 FXDLS.
#8020
Drained the three holes, removed the primary, and trying to do the 30T pulley swap but I just can't get that pulley nut off. I've tried the breaker bar, a little heat, and hitting it for 2 min at a time with the impact to no avail. Anyone have the part number for the six speed pulley nut? I can't seem to find one. Also, need to get the bearing puller and installer for the primary main shaft bearing and seal if anyone has suggestions on the tool to use.